MINI-INJECTOR CLEANER - EQUIPMENT FOR CLEANING & CHECKING INJECTOR
 |
|||||||||||||||||||||||||||||
 |
|||||||||||||||||||||||||||||
|
● Product code: CM1002 ● Origin: ● Availability: In stock ● Rate:   |
|||||||||||||||||||||||||||||
| ● INTRODUCTION | |||||||||||||||||||||||||||||
|
- Injector is the important actuator of electronic fuel
injection system (PGM-FI) on cars and motorcycles.
Although the supply power, electronic controller and
fuel pressure is have not fault but if the faults is
caused of mechanical reasons (e.g. Missing flow, dirty,
stuck, leak…) then it will affect on the amount of
spray, A/F ratio, fuel consumption and engine power.
Especially in some case, the fuel supply in some
countries is not clean, after about 10,000km operation,
the injector need to be maintained, cleaned and checked
periodically. However, injector cleaning and checking
equipment by traditional measuring tubes as INJECTOR
CLEANNER (product code: CM1001) is expensive and few
repairer can recheck injector after cleaning by
“graduated measuring tubes” method. - DTDAuto offer a other technology solution that check mechanical quality of injector by MOTOSCAN. It used “interpolation” method based on the A/F ratio, injection time (Ti) and fuel pressure (Pi). It can reach up to 90% accuracy compared with “measuring cylinder tube” method but it is more convenience and quicker. We are pleased to introduce MINI-INJECTOR CLEANER – Equipment for cleaning and checking injector by ultrasound technology and “interpolation” method in 2016 by DTDAUTO technology Team. |
|||||||||||||||||||||||||||||
 Equipment image |
|||||||||||||||||||||||||||||
| ● APPLICATION | |||||||||||||||||||||||||||||
|
- Used for almost fuel injector types of cars and
motorcycles in the market - Fuel injector maintaining and checking tool for the workshops - Study tools and training equipments for automotive/motorcycle vocational training |
|||||||||||||||||||||||||||||
| ● FUNCTION | |||||||||||||||||||||||||||||
 Block diagram for working process |
|||||||||||||||||||||||||||||
|
- Injector checking: This function is integrated in MOTOSCAN 5.8
or higher version - Ultrasonic cleaning (rinsing and cleaning by Ultrasonic) Drop submerged injectors then rinse and soak it in the ultrasonic tank with pulse generator to “active” activity of injector. It used to destroy dirties inside injector and put it out. This function is used to rinse, synchrony clean injectors by ultrasonic wave to destroy and reject dirties such as carbonized deposits in the injectors. - Technology and gadgets combined: Today, this is the most good and safe technology to destroy dirties on the material surface. It is like removing tartar technology or cleaning technology for surface of jewelry, machine cover and mechanical components and mechanical spare part as: piston, spark plug, crank shaft, ring, silver necklaces …You can view clip as below: |
|||||||||||||||||||||||||||||
|
Part1: Clean Injector by ultrasonic tank |
|||||||||||||||||||||||||||||
|
Part2: Clean other part (piston, spark plug, crank shaft ...) by ultrasonic tank |
|||||||||||||||||||||||||||||
| ● COMPONENT | |||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||
| ● RELEVANT DOCUMENTS | |||||||||||||||||||||||||||||
|
|||||||||||||||||||||||||||||
